ETI ADH-2A-COM DESCRIPTION
The ADH–2A COM Automatic Dehydrator sup plies low pressure -40°F (-40°C) maximum dew point air to keep waveguide and coax dry. The standard pressure is 0.5 psig (34.5 mbar) with 3 psig (207 mbar) and 6 psig (414 mbar) options. Standard features include automatic regeneration, alarm and low pressure relays and an RS-422/RS-485 communications interface thus making un at tend ed operation practical.
The ADH–2A COM uses LED displays and indicators to provide a wide viewing angle and good visibility under low-light conditions. Displayed information includes status, operating and fault di ag no sis data along with air pump operating time. The ADH–2A COM operates with exceptionally low noise and vibrations levels. The dehydrator uses aluminium oxide desiccant for high efficiency. The humidity sensor causes regeneration based upon cur rent dew point rather than at fixed time intervals for additional energy savings and long desiccant life. Dual micro controllers and solid state circuitry insure reliability.
The ADH–2A COM requires only 5-1/4″ of pan el space. An internal evaporator eliminates the need for a water drain. The dehydrator op er ates from 120/230 volts 50/60 Hz. A user-set jumper selects the display of either SI or English units. The ADH–2A COM consumes a maximum of 150 va during regeneration and approximately 60 va otherwise. Thus, this products creates and exceptionally low heat load for an automatic dehydrator.
Data Sheet: ETI_adh2acompump_23033AETI-ADH-2A-COM-DS
For more information, please contact us at sales@ai-sat.com